Brookfield QTS25 Texture Analyzer Manuel d'utilisateur télécharger pdf (Page 12)

QTS MATERIALS EVALUATION SYSTEM OPERATOR MANUAL

Page 12

h) To obtain an average Gram value by use of the Print key, Select ‘Print on request’

from printer menu.

Now when the print key is pressed, if a printer is connected the normal printed report

will be produced. In addition the LH display will show (No) TEST AV.=(Figure).

If no printer is connected then the LH display will show (No) TEST AV. = (Figure).

If you wish to add tests to same batch and rework statistics then press ENTER,

continue testing until required number of samples are completed, repeat the above. If

you wish to begin a new test from sample No.0 then you will have to enter new batch

number.

Press ABORT to return to “QTS Controller Ready”.

4.8

Configuration Settings

Press 'Configure' key. Use the up and down

↑↓

keys to Select utility:

a) < ..

Hardware set-up

.. >

Select utility : < .. Hardware set-up .. >

Press 'ENTER'

Select set-up option:

•

< . Test/setup utils . >

•

< . Keyboard beeper . >

•

< . Real time clock . >

•

< . No selection . >

•

< . Printer Output P/S.>

•

< . Printer LF Mode . >

Select using

Select set-up option: < . Test/setup utils .>

Press 'ENTER' Enter Password

Do not attempt to enter this set-up option. The password is only contained in the

service manual. Call your distributor or Brookfield Engineering Laboratories, Inc.

if help is required

Press 'ENTER'. Display returns to start up

message.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Brookfield QTS25 Texture Analyzer Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Brookfield QTS25 Texture Analyzer