Brookfield CT3 Texture Analyzer Manuel d'utilisateur télécharger pdf (Page 21)

Brookeld Engineering Labs., Inc. Page 21 Manual No. M08-372-C0113

Testresultsareshownonthereportingscreen:

CYCLE:XX 

PEAK MEAN: XXXX.X g

PEAK STDEV: XXXX.X g

PEAK LOAD: XXXX.X g

FINAL LOAD: XXXX.X g

TEMP: XXX.X F

III.14

Mean and standard deviation of all peaks is reported.

Peakloadisthehighestpeakandnalloadisthepeakloadofthelastcycle.

Temp shows temperature at time of last cycle peak, only if probe is connected.

BLOOM TEST – performs a single compression cycle using industry established test parameters

and reports gelatin bloom strength.

DeformationandtestspeedarexedintheBloomTestspecication.

TEST: BLOOM

TRIGGER: 4.5 G

DEFORMATION: 4.0 mm

SPEED: 0.5 mm/s

III.15

When the operator depresses the start button the Bloom test performs a single compression cycle

at 0.5mm/s to the target deformation of 4mm. During the test the running screen is seen as shown

below:

TEST: BLOOM

DEFORMATION:XXX.X mm

LOAD: XXXX.X g

III.16

Both Deformation and Load displays are live during the test. The probe then returns immediately

to home/starting position at 4.5mm/s.

Testresultsareshownonthereportingscreen:

BLOOM LOAD: XXXX.X g

TEMP: XXX.X F

III.17

Bloomloadingramsisgenerallyreportedas“gramsbloom”.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Pas de commentaire

Brookfield CT3 Texture Analyzer Manuel d'utilisateur Page 21