Brookfield DV2+Pro Viscometer Manuel d'utilisateur Page 32

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 101
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 31
Brookeld Engineering Labs., Inc. Page 32 Manual No. M03-165-F0612
Pressing the OPTIONS/TAB key “toggles” between the two port choices. To select a printer output
port, press the ENTER/AUTORANGE key while the desired choice is blinking. This will cause the
DV-II+Pro to direct all further printer output to the chosen port while remaining in the Setup
menu.YoumustpresstheENTER/AUTORANGEkeytoselecttheashingoption.
IV.2.5 Data Averaging
Youmustpressthe
ENTER/AUTORANGEkeytoselecttheashingoption.
Figure IV-12
This feature will perform a “rolling” average on the displayed % torque value and all other displayed
viscometerdataderivedfrom%torque.Youareallowedtoselectthenumberofreadingsover
which averaging is being done, with ten (10) readings as the maximum. There will be an initial
delayastherstaverageisperformedandthennoapparentdelayasthefollowingreadingsare
averaged (the viscometer takes approximately 4 readings per second). The rolling average is
described as follows.
1. The rst X readings are collected, placed in theaveraging buffer,averagedand the
average value is displayed.
2. Therstreadingintheaveragingbufferisdropped;thenextreading(theX+1reading)
is placed in the buffer and the buffer is again averaged and displayed. Step 2 is repeated
indenitelyuntiltheviscometerisshutoffortheuserselectsadifferentnumberof
readings to average. The number of readings to be averaged will include zero (0) as an
average so that this option may effectively be turned off without turning the viscometer
off.
Notes:
1. The data averaging will only be applied to the data displayed by the viscometer.
No data averaging will be applied to the torque output signal.
2. Data averaging is not applied to temperature.
3.Whendataaveragingtakingplace,aashingAwillbedisplayedtotheleftofthe
% Torque sign as shown in Figure IV-13.
CP 123.4 20.1C
10 RPM A% 19.7
Figure IV-13
DPRINT SERIAL #
DDATA AVERAGING $
Vue de la page 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 100 101

Commentaires sur ces manuels

Pas de commentaire