Brookfield RST Rheometer Manuel d'utilisateur télécharger pdf (Page 35)

Brookfield Engineering Labs., Inc. page 35 Manual No. M14-223

To select the type of measuring system, press the appropriate radio button:

• Cone

• Plate

• Vane

• Cylinder

• DG

• Custom

By selecting “Visible” you determine whether users selecting a measuring system in the measuring

program can see this measuring system.

Press OK to acknowledge your choice. On the next screen you enter the shear rate factor (K•Gamma)

and the shear stress factor (Tau Promill) using the numeric keyboard and acknowledge your entries with

OK:

Figure III-26

For cones, truncation must be entered in "m on the next screen:

Figure III-27

Acknowledge your entry with OK. Then enter the sample volume required for the measurement in

milliliters (mL) in the next mask and acknowledge with OK.

Figure III-28

Now your new or changed measuring system is durably stored in your RST-CPS Rheometer.

To correct input errors or check your entries you can always return to the previous input mask using

“Back”.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 68 69

Pas de commentaire

Brookfield RST Rheometer Manuel d'utilisateur Page 35